When I'm treating hairs with galvanic, some hairs tend to break off at the follicle opening when I try to remove it and so the lower part of hair remains with the bulb and sheath in the follicle. My vision aid is pretty good and I'm confident in my insertions accuracy because I can actually see the tip of the needle right at the correct length reaching the hair bulbs.
I don't pull hard on these hairs, and I can't blame it on resistance from lack of proper energy delivery.

Is this something that requires a correction in my technique or do hairs just break off occasionally?


Edited by fenix (07/24/17 06:37 PM)