Subscribe & Support This Site!
consumer hair removal forum
Page 1 of 2 1 2 >
Topic Options
Rate This Topic
Hop To:
#125074 - 11/07/17 01:24 PM Thinning Male Beard Question- NOT Complete Removal
Hang10 Offline
Contributor

Registered: 10/17/10
Posts: 48
Hi all,

I am a white straight male who is considering electrolysis on his beard/goatee area because my black facial hair grows in thick (both thick hair and the number of hairs per surface area) and I get razor burn. In addition. When I shave, I do not like the "5 o'clock" shadow or gray area that I have when clean shaven, but at the same time, I DO want to preserve my masculinity and not be completely bald on my face (this is NOT a trans case).

Ideally, my goal is what some guys naturally have, which is to be able to grow facial hair when I want, but when they shave, they do not have the shadow.

I have a few questions where your expertise will be helpful:

1) If I thin out my goatee area, will my face/facial hair still look natural (in the goatee area) when I shave or if I grow out the hair sometime in the future?

2) Assuming in point 1 will still look natural, how many hairs per (square inch?) area should I aim to have?

Any pictures or other commentary from the forum would be helpful.

I am scheduled to have an electrolysis treatment (90 minutes) later on this week, and was going to ask the practitioner to take the following approach:

1. Work on "thinning" out the goatee/chin area since there's a lot of hairs there
2. Lower beard line on the cheeks area (essentially a removal to a certain point)
3. Remove hairs above the chin but below the lower lip (those two oval-like areas where there is typically less hair)

A few additional questions:
1. Does this seem like a logical approach for the visit?
2. Will 90 minutes be enough to accomplish these items?
3. What settings should I ask for to ensure the hair doesn't grow back and that I have NO SCARRING or WHITE POCK marks (it is my face and will need to walk around the next day)
4. With respect to lowering my beard line, should I make sure the practitioner ensures there is a " gradual transition" from the area with hair to the non-hair area (e.g. is it natural to have lots of hair in the beard then no hair on the cheeks, or should it be hair on the beard gradually reducing to no hair on the cheeks)? - which approach is most natural should I ever decide to grow a beard?

Pardon for all the questions but it is my face, so I cannot have any mistakes or leaving things to chance.

I look forward to hearing back from the forum.

Top
Thread Sponsors
#125079 - 11/07/17 08:22 PM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Hang10]
Iluv2zap Offline
Top 10 Contributor

Registered: 11/19/14
Posts: 1150
first, it does indeed sound like yu know what you want.

no one here can give you any time estimate sight unseen , or predict what it will take an electrologist to perform that, that is something you learn through your consulatation.
a single 90 minute session will not suffice. Electrolysis treatments are spread out over 12-18 months whether clearing or thinning.

I've worked several cases on men who seek a thinning approach. to get a minimal thinning you can still be looking at 10 or more hours of electrolysis over the first 3 months alone. It's very possible to get a natural look this way through electrolysis. It is not possible to do it with laser however.


We have no way of predicting settings that would be appropriate for your situation, there are simply too many variables.

Everything you've written pretty much tells me to advise you to get that information fromyour electrologist during a consult. Neverhaving met you, seen your face, andwith zero information on your skin history, we honestly cant.
_________________________
Seana Richmond
Certified Electrologist.
Electrolysis By Seana
http://electrolysisbyseana.com

Top
#125122 - 11/11/17 08:19 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Hang10]
Josefa M. Reina Offline
Contributor

Registered: 05/15/17
Posts: 24
You should not apologize for asking for information about a process that is not easy, and with which, if someone makes a mistake, you will be the hardest hit.

Maybe the photos of a case in which I worked can help you see things a little clearer.

The first photo was taken right after a session in the beard density reduction work. I think you can see the area where the session was interrupted (higher hair density).



Here in more detail:



This was the original density, before the start:


This man's beard was fully developed when the process was carried out. The hairs were incredibly thick (as I had never seen or worked on). In my opinion the redesign of the line under the cheek, as well as the neckline is too low and too high, but that's the customer's choice, therefore, it was done as he wanted since it falls within the aesthetically acceptable.

I'm not going to lie, this is not an EASY job, neither for the client nor for the practitioner.

Another moment of the process. In this area, all hairs were treated and permanently removed:





Edited by Josefa M. Reina (11/11/17 08:34 AM)
Edit Reason: add pictures

Top
#125123 - 11/11/17 09:42 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Hang10]
Iluv2zap Offline
Top 10 Contributor

Registered: 11/19/14
Posts: 1150
josepha,

none of of your pictures are visible.
_________________________
Seana Richmond
Certified Electrologist.
Electrolysis By Seana
http://electrolysisbyseana.com

Top
#125124 - 11/11/17 09:46 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Hang10]
angelfeather Offline
Contributor

Registered: 05/11/17
Posts: 25
I can see them just fine

Top
#125125 - 11/11/17 10:46 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Iluv2zap]
Josefa M. Reina Offline
Contributor

Registered: 05/15/17
Posts: 24
Originally Posted By Iluv2zap
josepha,

none of of your pictures are visible.


Really? How strange, I can see them on my screen ...

Top
#125126 - 11/11/17 10:55 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Hang10]
fenix Offline
Top 10 Contributor

Registered: 03/17/12
Posts: 469
Photos don't show for me either. Each photo box has a message "please update your account to enable 3rd party hosting." I use postimage.org less issues than imageshack and photobucket.

Josefa when it comes to thinning beards what is the biggest challenge for you? Too bad electrology textbooks don't deal with the subject in depth.

Top
#125127 - 11/11/17 11:01 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: Hang10]
stoppit&tidyup Offline
Top 10 Contributor

Registered: 05/04/08
Posts: 1806
Loc: London, UK
Strange, I can see them embedded.
_________________________
31/F/UK
Laser for reduction on Underarms, Bikini, Full Legs & 3/4 Arms. Skin type IV
Electrolysis - Further details in: My sister's electrolysis diary
[27hrs of Blend, April 2008-Dec 2010 in UK, for coarse hair on lower sideburns, coarse chin hair, completed upper lip, shaped eyebrows]
[Sept 2011 to date, once yearly sessions with Josefa. Completed reduction of facial/neck fuzz in approx 27 hrs TTT]

Top
#125128 - 11/11/17 11:04 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: fenix]
Josefa M. Reina Offline
Contributor

Registered: 05/15/17
Posts: 24
Trying again:

Photo 1 [img:center][/img]

Photo 2
[img:center][/img]

Photo 3
[img:center][/img]

Photo 4

[img:center][/img]

Top
#125129 - 11/11/17 11:14 AM Re: Thinning Male Beard Question- NOT Complete Removal [Re: fenix]
Josefa M. Reina Offline
Contributor

Registered: 05/15/17
Posts: 24
Originally Posted By fenix
Photos don't show for me either. Each photo box has a message "please update your account to enable 3rd party hosting." I use postimage.org less issues than imageshack and photobucket.

Josefa when it comes to thinning beards what is the biggest challenge for you? Too bad electrology textbooks don't deal with the subject in depth.




Hi Fenix, I'm happy to hear from you smile The biggest challenge is the selection of hairs that have to be removed in order to obtain a homogeneous and natural result. Considering that certain areas such as chin, upper and lower lips should be denser (number of hairs per cm2) than the rest of the beard. If you remove too much at some point, you can leave a bald patch.

Top
Page 1 of 2 1 2 >

Moderator:  Andrea 
Sponsored Links
Recent Posts
Most natural looking hair removal method
by tyndn
Today at 08:59 AM
men shaving legs??
by tyndn
Today at 08:56 AM
Current Laser/IPL Models
by tyndn
Today at 08:50 AM
Advice for customers.
by Michael Bono
Today at 02:22 AM
After first clearance?
by Roselake21
Yesterday at 05:55 AM
Top Posters
LAgirl 9994
dfahey 9611
James W. Walker VII 8050
Andrea 4149
Michael Bono 3184
Who's Online
0 registered (), 105 Guests and 6 Spiders online.
Key: Admin, Global Mod, Mod