Subscribe & Support This Site!
consumer hair removal forum
Topic Options
Rate This Topic
Hop To:
#125278 - 11/26/17 02:06 PM Why didn't I feel much pain?
SecretSid Offline
Contributor

Registered: 11/06/17
Posts: 27
I went to a professional clinic, and she removed a hair on my arm for test using blend method. She said that it hurts a lot, but I almost didn't feel anything. I told her that I didn't feel much, she said that I was lucky.

I asked her what current she used, she said about 0,8 on Thermolysis and a little bit below 2 on current galvanic.

In my head, this level of intensity is very low, however I am not an expert. So my question is: did she use low intensity on purpose to do a sell and make me come back? Is that a trick professional electrologist use? OR am I lucky as she said?

Based on this source:
http://www.sterex.com/learning-resources/section6/

To establish the ‘working point', you have to set the Thermolysis (SWD) intensity to 0.4 and set the Galvanic intensity to 20 (If you use technique 1).

She was far below this intensity.

Top
Thread Sponsors
#125280 - 11/27/17 05:04 AM Re: Why didn't I feel much pain? [Re: SecretSid]
SecretSid Offline
Contributor

Registered: 11/06/17
Posts: 27
Btw, I just read Michael Bono's short version book, and understand that sterex-method for establishing the working point is wrong, according to this book.



Edited by SecretSid (11/27/17 06:05 AM)

Top

Moderator:  Andrea 
Sponsored Links
Recent Posts
Electrolysis on female back
by Pkanji
04:22 PM
LHR for Blond, Red, Grey & White hair, any success
by Michael Bono
10:36 AM
Pro-Tec Probes Recommendations for Apilus
by Iluv2zap
10/20/18 08:30 PM
Unwanted hair - help/advice!
by EUGuy
10/20/18 04:27 PM
PCOS over-diagnosed
by Michael Bono
10/20/18 04:19 PM
Top Posters
LAgirl 9994
Deedra 9726
James W. Walker VII 8055
Andrea 4158
Michael Bono 3515
Who's Online
0 registered (), 126 Guests and 2 Spiders online.
Key: Admin, Global Mod, Mod