Subscribe & Support This Site!
consumer hair removal forum
Topic Options
Rate This Topic
Hop To:
#125278 - 11/26/17 02:06 PM Why didn't I feel much pain?
SecretSid Offline
Contributor

Registered: 11/06/17
Posts: 26
I went to a professional clinic, and she removed a hair on my arm for test using blend method. She said that it hurts a lot, but I almost didn't feel anything. I told her that I didn't feel much, she said that I was lucky.

I asked her what current she used, she said about 0,8 on Thermolysis and a little bit below 2 on current galvanic.

In my head, this level of intensity is very low, however I am not an expert. So my question is: did she use low intensity on purpose to do a sell and make me come back? Is that a trick professional electrologist use? OR am I lucky as she said?

Based on this source:
http://www.sterex.com/learning-resources/section6/

To establish the ‘working point', you have to set the Thermolysis (SWD) intensity to 0.4 and set the Galvanic intensity to 20 (If you use technique 1).

She was far below this intensity.

Top
Thread Sponsors
#125280 - 11/27/17 05:04 AM Re: Why didn't I feel much pain? [Re: SecretSid]
SecretSid Offline
Contributor

Registered: 11/06/17
Posts: 26
Btw, I just read Michael Bono's short version book, and understand that sterex-method for establishing the working point is wrong, according to this book.



Edited by SecretSid (11/27/17 06:05 AM)

Top

Moderator:  Andrea 
Sponsored Links
Recent Posts
A sterm warning to anyone considering laser hair removal.
by Miamikitty
1 second ago
Guidance on after care
by HairByHair
Today at 07:00 AM
Newbie journey
by MrsV
Yesterday at 10:54 PM
Best Laser Hair Removal UAE
by Deedra
Yesterday at 10:52 PM
Electrologist referral
by Arlene R. Batz, CPE
Yesterday at 06:08 PM
Top Posters
LAgirl 9994
Deedra 9711
James W. Walker VII 8055
Andrea 4158
Michael Bono 3490
Who's Online
1 registered (Miamikitty), 145 Guests and 7 Spiders online.
Key: Admin, Global Mod, Mod