I have one more question. Instead of creating a new thread, I just post it her.
I went to a professional clinic, and she removed a hair on my arm for testm using blend method. She said that it hurts a lot, but I almost didn't feel anything. I told her that, she said that I was lucky.
I asked her what current she used, she said about 0,8 on Thermolysis and a little bit below 2 on current galvanic.
In my head, this level of intensity is very low, however I am not an expert. So my question is, did she used low intensity on purpose to make me come back and do a sell, or am I lucky as she said?
Based on this source: http://www.sterex.com/learning-resources/section6/
To establish the ‘working point', you have to set the Thermolysis (SWD) intensity to 0.4 set the Galvanic intensity to 20 (If you use technique 1).
She was far below this intensity.